![]() ![]() The most important thing is any mistakes in the connection may damage the display module or Wemos board. It Is really handy during the soldering and you will save a lot of time also. Tinning is required as it makes the soldering process easier and strong bonding between the wire and header pins.įinally, solder the wires to all the header pins as shown in the above picture.įirst, download the schematic diagram, then take a printout. Then tin the header pins by using a small amount of solder on the soldering iron tip. I prefer the second one, it is much easier and requires less effort and skill.īefore soldering apply a small amount of soldering flux to all the header pins. Desolder the header pins from the PCB and then solder the wires to the soldering pads ![]() ![]() The TFT display has pre-soldered straight header pins to mount it to the breadboard or any other shield. Then strip out the insulation from the wires by using a Wire Stripper. Here, I have selected 30 AWG single-stranded wires.Ĭut 14 numbers of wires with equal length by using a Nipper. So, we have to select thin wires to make the connection between the display unit and Wemos Board. But the enclosure that I am going to use is very compact, and there is little room to keep the Wemos board along with the connecting wires inside the housing. My plan is to place the weather display circuit inside a 3D-printed enclosure. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |